xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
476
config dhcp pool netbios_node_type
Purpose
Used to specify the NetBIOS node type for a Microsoft DHCP client.
Syntax config dhcp pool netbios_node_type <pool_name 12> [broadcast | peer_to_peer |
mixed | hybrid]
Description
The NetBIOS node type for Microsoft DHCP clients can be one of four settings: broadcast,
peer-to-peer, mixed, or hybrid.
This command is used to configure NetBIOS over a TCP/IP device.
By default, NetBIOS node type is broadcast.
Parameters <pool name 12> – Specifies the name of the pool.
<node type> – Specifies the NetBIOS node type for a Microsoft DHCP client.
Restrictions
Only Administrator and Operator and Power-User-level users can issue this command.
Example usage:
To configure the NetBIOS node type:
DES-3528:admin# config dhcp pool netbios_node_type accounting hybrid
Command: config dhcp pool netbios_node_type accounting hybrid
Success.
config dhcp pool default_router
Purpose
Used to specify the IP address of the default router for a DHCP client. Up to three IP
addresses can be specified in one command line.
Syntax config dhcp pool default_router <pool_name 12> {< ipaddr>} {< ipaddr>} {< ipaddr>}
Description
After a DHCP client has booted, the client begins sending packets to its default router. The IP
address of the default router should be on the same subnet as the client.
If the default_router is not specified, the default router information will not be provided to the
client.
If this command is entered twice in the same pool, the second command will overwrite the
first command.
Parameters <pool name 12> – Specifies the name of the pool.
<ipaddr> – Specifies the IP address of the default router.
Restrictions
Only Administrator and Operator and Power-User-level users can issue this command.
Example usage:
To configure the default router:
DES-3528:admin# config dhcp pool default_router accounting 10.10.10.1
Command: config dhcp pool default_router accounting 10.10.10.1
Success.
To Next Page
Loading...
Need help?
General