D-Link xStack DES-3528 Series

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
501
clear cfm pkt_cnt
Purpose
Used to clear the CFM packet RX/TX counters.
Syntax clear cfm pkt_cnt {[ports <portlist> {[rx | tx]} | [rx | tx] | ccm]}
Description
This command clears CFM packet counters.
Parameters ports – Specifies which ports’ counter to show. If not specified, all ports will be shown.
{rx | tx} – Shows RX or TX packet counter. If none is specified, both of them are shown.
ccm - Shows the CCM transmission state.
Restrictions
Only Administrator and Operator and Power-User-level users can issue this command.
Example usage:
To clear the CFM packet RX/TX counters:
DES-3528:admin# clear cfm pkt_cnt ports 2 rx
Command: clear cfm pkt_cnt ports 2 rx
Success.
DES-3528:admin#
config cfm mp_ltr_all
Purpose
Used to configure the CFM mp linktrace on the Switch.
Syntax config cfm mp_ltr_all [enable | disable]
Description
This command configures the CFM mp linktrace on the Switch.
Parameters enable – Used to enable the CFM mp linktrace.
disable – Used to disable the CFM mp linktrace.
Restrictions
Only Administrator and Operator and Power-User-level users can issue this command.
Example usage:
To configure CFM mp linktrace:
DES-3528:admin# config cfm mp_ltr_all enable
Command: config cfm mp_ltr_all enable
Success.
DES-3528:admin#
show cfm mp_ltr_all
Purpose
Used to display the CFM mp linktrace settings on the Switch.
Syntax show cfm mp_ltr_all
Description
This command displays the CFM mp linktrace settings on the Switch.
Parameters
None.
Restrictions
None.
Example usage:
To show the CFM mp linktrace on the Switch:
DES-3528:admin# show cfm mp_ltr_all
Command: show cfm mp_ltr_all
All MPs reply LTRs: Enabled
DES-3528:admin#