D-Link xStack DES-3528 Series - Page 51

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
51
show snmp community
Purpose
Used to display SNMP community strings configured on the Switch.
Syntax show snmp community {<community_string 32>}
Description
This command is used to display SNMP community strings that are configured on the Switch.
Parameters
<community_string 32> − An alphanumeric string of up to 32 characters that is used to
identify members of an SNMP community. This string is used like a password to give remote
SNMP managers access to MIB objects in the Switch’s SNMP agent.
Restrictions
None.
Example usage:
To display the currently entered SNMP community strings:
DES-3528:admin# show snmp community
Command: show snmp community
SNMP Community Table
Community Name View Name Access Right
-------------- ----------- ------------
dlink ReadView read_write
private CommunityView read_write
public CommunityView read_only
Total Entries: 3
DES-3528:admin#
config snmp engineID
Purpose
Used to configure a name for the SNMP engine on the Switch.
Syntax config snmp engineID <snmp_engineID 10-64>
Description
This command configures a name for the SNMP engine on the Switch.
Parameters
<snmp_engineID 10-64> − An alphanumeric string that will be used to identify the SNMP
engine on the Switch.
Restrictions
Only Administrator-level users can issue this command.
Example usage:
To give the SNMP agent on the Switch the name “0035636666”:
DES-3528:admin# config snmp engineID 0035636666
Command: config snmp engineID 0035636666
Success.
DES-3528:admin#