To Next Page

To Previous Page

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide

511

show autoconfig

Purpose

This command is used to display if the auto-configuration is enabled or disabled.

Syntax show autoconfig

Description

This command is used to display if the auto-configuration is enabled or disabled.

Parameters

None.

Restrictions

None.

Example usage:

To show autoconfig status:

DES-3528:admin# show autoconfig

Command: show autoconfig

Autoconfig State : Disabled

DES-3528:admin#

Table of Contents2
Introduction5
Using the Console CLI7
Command Syntax10
Basic Switch Commands13
Modify Banner and Prompt Commands28
Switch Port Commands31
Port Security Commands35
Stacking Commands40
Network Management (SNMP) Commands44
Switch Utility Commands64
Network Monitoring Commands71
Multiple Spanning Tree Protocol (MSTP) Commands87
Forwarding Database Commands98
Traffic Control Commands105
Qos Commands110
Port Mirroring Commands120
VLAN Commands123
Voice VLAN Commands140
Subnet-Based VLAN Commands146
Asymmetric VLAN Commands149
Link Aggregation Commands151
IP-MAC-Port Binding (IMPB) Commands156
Limited IP Multicast Address Commands172
Basic IP Commands177
Multicast VLAN Commands183
IGMP / MLD Snooping Commands198
DHCP Relay Commands231
Commands (Including Guest Vlans)244
Access Control List (ACL) Commands262
Safeguard Engine Commands284
Filter Commands (DHCP Server / Netbios)287
Layer 3 CPU Filter Commands292
Loop-Back Detection Commands294
Traffic Segmentation Commands299
Sflow Commands301
Time and SNTP Commands309
ARP and Gratuitous ARP Commands315
Routing Table Commands322
MAC Notification Commands324
Access Authentication Control Commands327
Secure Shell (SSH) Commands348
Secure Sockets Layer (SSL) Commands355
D-Link Single IP Management Commands360
JWAC Commands369
Link Layer Discovery Protocol (LLDP) Commands386
Q-In-Q Commands405
RSPAN Commands411
Static MAC-Based VLAN Commands415
Simple RED Commands417
MAC-Based Access Control Commands424
Web-Based Access Control Commands435
Power over Ethernet (Poe) Commands444
Pppoe Circuit ID Insertion Commands449
DNS Relay Commands451
Policy Route Commands454
BPDU Attack Protection Commands457
Ethernet OAM Commands461
DHCP Server Commands471
Cable Diagnostics Commands484
Connectivity Fault Management Commands485
Command History Commands505
ARP Spoofing Prevention Commands507
Auto-Configuration Commands509
Compound Authentication Commands512
Debug Software Commands520
Dhcpv6 Client Commands525
Dhcpv6 Relay Commands527
D-Link Unidirectional Link Detection (DULD) Commands533
Ethernet Ring Protection Switching (ERPS) Commands535
Ipv6 Neighbor Discover Commands545
Ipv6 Route Commands549
Layer 2 Protocol Tunneling (L2PT) Commands551
Local Route Commands554
MSTP Debug Enhancement Commands556
Ping Commands560
Show Technical Support Commands562
Trace Route Commands565
VLAN Counter Commands567
Power Saving Commands570
Digital Diagnostic Monitoring (DDM) Commands578
Command Logging Commands585
UDP Helper Commands587
Appendix A - Password Recovery Procedure591
Appendix B - System Log Entries592
Appendix C - Trap Entries598
Appendix D - RADIUS Attributes Assignment603

Brand	D-Link
Model	xStack DES-3528 Series
Category	Switch
Language	English

D-Link xStack DES-3528 Series Cli Reference Guide

Table of Contents

Other manuals for D-Link xStack DES-3528 Series

Questions and Answers:

D-Link xStack DES-3528 Series Specifications

Related product manuals