D-Link xStack DES-3528 Series - Page 526

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
526
DES-3528:admin# debug dhcpv6_client state enable
Command: debug dhcpv6_client state enable
Success.
DES-3528:admin#
debug dhcpv6_client output
Purpose
Used to set debug message to output to buffer or console.
Syntax debug dhcpv6_client output [buffer | console]
Description
Used to set debug message to output to buffer or console.
Parameters buffer - Let the debug message output to buffer.
console - Let the debug message output to console.
Restrictions
Only Administrator-level users can issue this command.
Example usage:
To set debug information to output to console:
DES-3528:admin# debug dhcpv6_client output console
Command: debug dhcpv6_client output console
Success.
DES-3528:admin#
debug dhcpv6_client packet
Purpose
Used to enable or disable debug information flag for DHCPv6 client packet, including packet
receiving and sending.
Syntax debug dhcpv6_client packet {all | receiving | sending} state [enable | disable]
Description
Used to enable or disable debug information flag for DHCPv6 client packet, including packet
receiving and sending.
Parameters all - (Optional) Set packet receiving and sending debug flags.
receiving - (Optional) Set packet receiving debug flag.
sending - (Optional) Set packet sending debug flag.
state - Specifies that the designated flags will be enabled or disabled.
enable - Enable the designated flags.
disable - Disable the designated flags.
Restrictions
Only Administrator-level users can issue this command.
Example usage:
To enable dhcpv6_client packet sending debug:
DES-3528:admin# debug dhcpv6_client packet sending state enable
Command: debug dhcpv6_client packet sending state enable
Success.
DES-3528:admin#