D-Link xStack DES-3528 Series - Page 530

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
530
DES-3528:admin#show dhcpv6_relay
Command: show dhcpv6_relay
DHCPv6 Relay Global State : Enabled
DHCPv6 Hops Count Limit : 4
---------------------------------------------------------------
IP Interface : System
DHCPv6 Relay Status : Enabled
Server Address :
Total Entries : 1
DES-3528:admin#
To show the DHCPv6 relay configuration of System interfaces:
DES-3528:admin#show dhcpv6_relay ipif System
Command: show dhcpv6_relay ipif System
DHCPv6 Relay Global State : Enabled
DHCPv6 Hops Count Limit : 4
---------------------------------------------------------------
IP Interface : System
DHCPv6 Relay Status : Enabled
Server Address :
DES-3528:admin#
debug dhcpv6_relay state
Purpose
Use this command to enable or disable DHCPv6 relay Debug function.
Syntax debug dhcpv6_relay state [enable | disable]
Description
Use this command to enable or disable DHCPv6 relay Debug function.
Parameters state - Specifies if the DHCPv6 relay debug function will be enabled or disabled.
enable - Enable the DHCPv6 relay debug function.
disable - Disable the DHCPv6 relay debug function.
Restrictions
Only Administrator-level users can issue this command.
Example usage:
To enabled DHCPv6 relay debug function:
DES-3528:admin# debug dhcpv6_relay state enable
Command: debug dhcpv6_relay state enable
Success.
DES-3528:admin#