D-Link xStack DES-3528 Series - Page 536

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
536
DES-3528:admin# enable erps
Command: enable erps
Success.
DES-3528:admin#
disable erps
Purpose
This command is used to disable the global ERPS function on a Switch.
Syntax disable erps
Description
This command is used to disable the global ERPS function on a Switch.
Parameters
None.
Restrictions
Only Administrator, Operator and Power User-level users can issue this command.
Example usage:
To disable ERPS:
DES-3528:admin# disable erps
Command: disable erps
Success.
DES-3528:admin#
create erps raps_vlan
Purpose
This command is used to create an R-APS VLAN on a Switch.
Syntax create erps raps_vlan <vlanid>
Description
Only one R-APS VLAN should be used to transfer R-APS messages.
Note that the R-APS VLAN must already have been created by the create vlan command.
Parameters raps_vlan - Specifies the VLAN which will be the R-APS VLAN.
<vlanid> - Enter the VLAN ID used here.
Restrictions
Only Administrator, Operator and Power User-level users can issue this command.
Example usage:
To create an R-APS VLAN:
DES-3528:admin# create erps raps_vlan 4094
Command: create erps raps_vlan 4094
Success.
DES-3528:admin#
delete erps raps_vlan
Purpose
This command is used to delete an R-APS VLAN on a Switch.
Syntax delete erps raps_vlan <vlanid>
Description
When an R-APS VLAN is deleted, all parameters related to this R-APS VLAN will also be
deleted. This command can only be issued when the ring is not active.
Parameters raps_vlan - Specifies the VLAN which will be the R-APS VLAN.
<vlanid> - Enter the VLAN ID used here.
Restrictions
Only Administrator, Operator and Power User-level users can issue this command.
Example usage:
To delete an R-APS VLAN: