D-Link xStack DES-3528 Series - Page 544

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
544
config erps raps_vlan sub_ring raps_vlan tc_propagation state
Purpose
This command is used to configure the state of topology change propagation for the sub-ring.
Syntax config erps raps_vlan <vlanid> sub_ring raps_vlan <vlanid> tc_propagation state
[enable | disable]
Description
This command is applied on the interconnection node.
Parameters raps_vlan - Specifies the R-APS VLAN.
<vlanid> - Enter the R-APS VLAN ID here.
sub_ring - Specifies that the sub-ring is being configured.
raps_vlan - Specifies the R-APS VLAN.
<vlanid> - Enter the VLAN ID used here.
tc_propagation - Specifies that the topology propagation state will be configured.
state - Specifies the topology propagation state.
enable - Enable the propagation state of topology change for the sub-ring.
disable - Disable the propagation state of topology change for the sub-ring. The default value
is disabled.
Restrictions
Only Administrator, Operator and Power User-level users can issue this command.
Example usage:
To configure the state of topology change propagation:
DES-3528:admin# config erps raps_vlan 4094 sub_ring raps_vlan 4093 tc_propagation
state enable
Command: config erps raps_vlan 4094 sub_ring raps_vlan 4093 tc_propagation state
enable
Success.
DES-3528:admin#