D-Link xStack DES-3528 Series - Page 575

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
575
DES-3528:admin#config power_saving mode port hibernation enable
Command: config power_saving mode port hibernation enable
Success.
DES-3528:admin#
show power_saving
Purpose
This command is used to display the setting of power saving function.
Syntax show power_saving {length_detection | link_detection | led | port | hibernation}
Description
This command is used to display the setting of power saving function.
Parameters length_detection - Display the length detection configuration of power saving.
link_detection - Display the link detection configuration of power saving.
led - Display the port LED configuration of power saving.
port - Display the port configuration of power saving.
hibernation - Display the system hibernation configuration of power saving.
Restrictions
None.
Example usage:
To display all power saving configurations:
DES-3528:admin#show power_saving
Command: show power_saving
Link Detection State: Enabled
Length Detection State: Enabled
Power Saving Configuration On System Hibernation
----------------------------------------------------
State: Enabled
Time Range
--------------------------------
range_1
Power Saving Configuration On Port LED
------------------------------------------
State: Disabled
Time Range
--------------------------------
range_1
Power Saving Configuration On Port
------------------------------------------
State: Enabled
Port Time Range
------- --------------------------------
1:1 range_1
DES-3528:admin#
To display power saving configuration on system hibernation: