D-Link xStack DES-3528 Series

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
82
delete syslog host
Purpose
This command is used to delete the specific syslog host.
Syntax delete syslog host [<index 1-4> | all]
Description
This command is used to remove a syslog host that has been previously configured from the
Switch.
Parameters
<index 1-4> − Specifies that the command will be applied to an index of hosts. There are four
available indexes, numbered 1 through 4.
all − Specifies that the command will be applied to all hosts.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example usage:
To delete a previously configured syslog host:
DES-3528:admin# delete syslog host 4
Command: delete syslog host 4
Success.
DES-3528:admin#
show syslog host
Purpose
This command is used to show syslog the host information.
Syntax show syslog host {<index 1-4>}
Description
This command is used to display the syslog hosts that are currently configured on the
Switch.
Parameters
<index 1-4> − Specifies that the command will be applied to an index of hosts. There are four
available indexes, numbered 1 through 4.
Restrictions
None.
Example usage:
To show Syslog host information:
DES-3528:admin#show syslog host
Command: show syslog host
Syslog Global State: Disabled
Host 1
IP Address : 192.168.69.123
Severity : Critical(2)
Facility : Local0
UDP Port : 514
Status : Enabled
Total Entries : 1
DES-3528:admin#