D-Link xStack DES-3528 Series - Page 95

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide
95
Hello Time : 2
Forward Delay : 15
Max Hops : 20
TX Hold Count : 6
Forwarding BPDU : Disabled
NNI BPDU Address : dot1ad
DES-3528:admin#
Status 2 : STP enabled for RSTP
DES-3528:admin# show stp
Command: show stp
STP Bridge Global Settings
---------------------------
STP Status : Enabled
STP Version : RSTP
Max Age : 20
Hello Time : 2
Forward Delay : 15
Max Hops : 20
TX Hold Count : 6
Forwarding BPDU : Disabled
NNI BPDU Address : dot1ad
DES-3528:admin#
Status 3 : STP enabled for MSTP
DES-3528:admin# show stp
Command: show stp
STP Bridge Global Settings
---------------------------
STP Status : Enabled
STP Version : MSTP
Max Age : 20
Forward Delay : 15
Max Hops : 20
TX Hold Count : 6
Forwarding BPDU : Disabled
NNI BPDU Address : dot1ad
DES-3528:admin#
show stp ports
Purpose
Used to display the Switch’s current STP ports configuration.
Syntax show stp ports <portlist>
Description
This command displays the STP ports settings for a specified port or group of ports (one port
at a time).
Parameters
<portlist> − Specifies a port or range of ports to be viewed. Information for a single port is
displayed. If no ports are specified the STP information for port 1 will be displayed. Users
may use the Space bar, p and n keys to view information for the remaining ports.
Restrictions
None.
Example usage:
To show STP ports information for port 1 (STP enabled on Switch):