20
Repeat above steps, until it is paired successfully. Alternatively, slide the
tamperproof switch of the case manually to make red light flash fast until it is
paired successfully.
● Zone no. of wireless detector starts from 3 in sequence.
● Zone no. of wireless siren starts from 44 in sequence.
● Zone no. of wireless panic button starts from 35 in sequence.
Taking “wireless PIR detector” for example, position of shell tamper switch is
shown in Figure 4-14.
Figure 4-14
Remote control enrollment
Press any key for 3s. If this remote control info is displayed on LCD screen, it
means that enrollment is successful; otherwise, enrollment has failed; please
enroll again.
Channel no. of wireless remote control starts from 35 in sequence.
4.4.2 Delete Wireless Device
Step 1 In the homepage, press [ ] or [ ], select “Setting” and press [OK].
Step 2 Press [ ] or [ ], select “Enroll” and press [OK].
The interface is shown in Figure 4-15.
To Next Page
Loading...