Dahua ARC5402A-GW - Delete RFID Card; Zone Setting

25
Figure 4-21
Step 4 Swipe FRID card in the card-swiping zone.
Display ID, representing successful identification. Then, press [ ] or [ ], select
“Name” text box and press [OK] to enter card name.
Step 5 Press [ ] or [ ], select “Save” and press [OK] to save the settings.
4.6.2 Delete RFID Card
Step 1 In the homepage, press [ ] or [ ], select “Setting” and press [OK].
Step 2 Press [ ] or [ ], select “RFID” and press [OK].
Step 3 Press [ ] or [ ], select and press [OK] to delete this RFID card.
4.7 Zone Setting
Set zone name and linkage parameters during alarm.
Step 1 In the homepage, press [ ] or [ ], select “Setting” and press [OK].
Step 2 Press [ ] or [ ], select “Zone” and press [OK].
The interface is shown in Figure 4-22.