26
Figure 4-22
Step 3 Press [ ] or [ ], select a zone to be set and press [OK].
The interface is shown in Figure 4-23.
Figure 4-23
Step 4 Press [ ] or [ ], select parameters and press [OK] to select or modify.
For specific parameter descriptions, please refer to Table 4-3.
Set zone name, which will be shown in linkage SMS in case of alarm
linkage. For specific settings, please refer to “Appendix 1 Operating
Instructions of Input Method”.
It is identified automatically and cannot be set.
After selection, output a linkage alarm when an alarm is triggered in
the zone.
After selection, internal siren will send sound when an alarm is
triggered in the zone.
After selection, siren will send an alarm when an alarm is triggered in
the zone.
After selection, alarm info will be sent by SMS when an alarm is
triggered in the zone.
To Next Page
Loading...
Need help?
General