Dahua ARC5402A-GW - RFID Management

23
Figure 4-19
Press [ ] or [ ], select corresponding parameter text box, input numbers, or 2.
input them by reference to “Appendix 1 Operating Instructions of Input Method”.
For specific parameter descriptions, please refer to Table 4-2.
Parameter
Description
Channel
The system identifies idle channel number automatically,
which cannot be modified.
Rstp Port
Input RTSP port number of the camera. It is 554 by
default.
Http Port
Input HTTP communications port number of the camera.
It is 80 by default.
TCP Port
It is service port of TCP protocol, to be set according to
the user’s actual needs. It is 37777 by default.
IP Address
Input IP address of the camera.
Username/
Password
Input username and password to login the camera.
Protocol
Select from Private and Onvif according to actual
conditions. Press [OK] to switch.
Pre-record
Pre-record time before linkage alarm recording.
At most 2 cameras can enable pre-record function.
Table 4-2
Press [ ] or [ ], select “Save” and press [OK] to save the settings. 3.
4.5.2 Modify/View Camera Parameters
Step 1 In the homepage, press [ ] or [ ], select “Setting” and press [OK].
Step 2 Press [ ] or [ ], select “Camera” and press [OK].
Step 3 Press [ ] or [ ], select “Parameter” and press [OK].
Display connection info about this camera.
Step 4 Modify camera info by reference to manual adding description in “4.5.1 Add Camera”.