Daikin Altherma 3 R ECH2O - Removing the Bottom Thermal Insulation; Opening the Air Purge Valve

3 Set-up and installation
Installation and operating manual
15
Daikin Altherma EHS(X/H)(B)-D
Daikin Altherma 3 R ECH₂O
008.1451099_00 – 07/2020
 3‒10 Open the switch box
3 Hook in the cover on the switch box with the lateral hooks.
 3‒11 Hooking in the cover
3.4.5 Removing the bottom thermal insulation
CAUTION
The thermal insulation consists of pressure-sensitive EPP
moulded parts that can be easily damaged if not handled
correctly.
▪ Only remove the thermal insulation in the order stated
below and in the stated directions.
▪ Do not use force.
▪ Do not use tools.
1 Remove the thermal insulation in the following order:
▪ Pull the side insulating element off horizontally (itema).
▪ Pull the rear insulating element off horizontally (itemb).
▪ Pull the front insulating element off horizontally (itemc).
 3‒12 Removing the top thermal insulation
a Side insulating element
b Rear insulating element
c Front insulating element
2 As required: Remove the bottom thermal insulation in the
following order:
▪ Pull the side insulating element off vertically (itema).
▪ Pull the rear insulating element off vertically (itemb).
 3‒13 Removing the bottom thermal insulation
a Side insulating element
b Rear insulating element
INFORMATION
The thermal insulation is installed in reverse order.
3.4.6 Opening the air purge valve
1 Removing the thermal insulation (see "3.4.5 Removing the
bottom thermal insulation"[415]).
2 Open the air purge valve on the pump by one turn.