Daikin R407C PLUS - Drawings & Flow Charts

Si33-105
Drawings & Flow Charts v
Drawings & Flow Charts
Drawings & Flow ChartsDrawings & Flow Charts
Drawings & Flow Charts
Numerics
4-way valve changeover control
(starting control)
..............................................62
4-Way Valve Changeover Ensuring Control
..........57
A
Abnormal Discharge Pipe Temperature ...............174
Actuation of High Pressure Switch
.......................171
Actuation of Low Pressure Sensor
.......................172
Actuation of Safety Device
...................................169
Address Duplication of Central Remote
Controller
......................................................190
Address Duplication, Improper Setting
........ 208
,
213
B
BS unit connection range and total indoor unit
capacity
.............................................................6
BS unit Refrigerant System Diagram
BSVP100KJV1
................................................37
BSVP160KJV1
................................................38
BSVP250KJV1
................................................38
C
Centralized Control Group No. Setting
BRC1A51·52
..................................................132
BRC7A Type
..................................................132
BRC7C Type
.................................................133
Group No. Setting Example
...........................133
Check Operation.
.................................................105
Check The Following Before
Turning Power On.
........................................104
Compressor ON/OFF Conditions
...........................64
Compressor Sequence Operation
.........................67
Contents of Control Modes
How to Select Operation Mode
......................134
Correction of Td with Outdoor Temperature
..........52
Crankcase Heater Control
.....................................64
D
Defrosting operation ...............................................92
Demand Control System Example
.......................120
Diode Module
.......................................................245
Display “Under Host Computer Integrate Control”
Blinks (Repeats Double Blink)
......................217
Display “Under Host Computer Integrate Control”
Blinks (Repeats Single Blink)
........................215
Display of sensor and address data
.....................152
Drain Level above Limit
.......................................163
Drain Pump Control
When the Float Switch is Tripped and “AF” is
Displayed on the Remote Controller
...98
When the Float Switch is Tripped During
Cooling OFF by Thermostat
...............97
When the Float Switch is Tripped During
Heating Operation
..............................98
When the Float Switch is Tripped While the
Cooling Thermostat is ON
................. 97
Drooping due to Outdoor Temperature
................. 83
E
Equalizing Startup Control .................................... 60
Error of External Protection Device
..................... 157
Excessive Number of Indoor Units
...................... 188
F
Fan Location ......................................................... 96
Fan Motor (M1F) Lock, Overload
........................ 160
Flow of Refrigerant in Each Operating Mode
Cooling Operation
........................................... 39
Heating Operation
........................................... 41
Oil Return Operation-Discharge (at Heating and
Simultaneous Cooling / Heating
Operation or Defrost Operation)
........ 42
Oil Return Operation-Suction (at Cooling and
Heating and Simultaneous Cooling /
Heating Operation or
Defrost Operation)
............................. 43
Simultaneous Cooling / Heating Operation
..... 40
Forced fan ON
..................................................... 152
Freeze Prevention
............................................... 102
Function of setting between cooling
and heating
.................................................. 108
Function setting mode switch and LED
............... 108
H
Heating Pump-Down Residual Operation
(Heating & Simultaneous Cooling /
Heating Operation)
......................................... 94
High Pressure Protection Control
Cooling and simultaneous cooling / heating
operation mode
.................................. 79
Oil return mode
(common for cooling / heating)
.......... 79
How to Enter the Service Mode
.......................... 151
I
Improper Combination of Optional Controllers for
Centralized Control
.............................. 207
,
212
Individual setting
................................................. 152
Indoor Field Setting
Wired Remote Controller
.............................. 126
Wired Remote Controller – Heat Reclaim
Ventilation
........................................ 127
Wireless Remote Controller
.......................... 128
Indoor Unit Operation Flowchart
......................... 139
Inverter Instantaneous Over-Current
.................. 196
Inverter Over-Ripple Protection
........................... 202
Inverter Protection Control
.................................... 79
Inverter Stall Prevention, Compressor Lock
........ 198