Danfoss Vacon NXP Series - Page 98

Code Function Min Max Unit Default Cust Description
S6.2 Application selection Basic applica-
tion
Basic application
Standard application
Local/Remote control appl.
Multi-Step application
PID Control application
Multi-Purpose Control appl.
Pump and Fan Control
appl.
S6.3 Copy parameters
S6.3.1 Parameter sets Store set 1
Load set 1
Store set 2
Load set 2
Load factory defaults
S6.3.2 Load up to keypad All parameters
S6.3.3 Load down from keypad All parameters
All but motor parameters
Application parameters
P6.3.4 Parameter back-up Yes Yes
No
S6.4 Compare parameters
S6.4.1 Set1 Not used
S6.4.2 Set 2 Not used
S6.4.3 Factory settings
S6.4.4 Keypad set
S6.5 Security
S6.5.1 Password Not used 0 = Not used
P6.5.2 Parameter lock Change Ena-
bled
Change Enabled
Change Disabled
S6.5.3 Start-up wizard No
Yes
Using the Control Panel
Operating guide | VACON® NXS/NXP Air-cooled
DPD00910G
98 | Danfoss A/S © 2018.06