Danfoss VLT AutomationDrive FC 302

Option
Name
Description
[196]
Reset emcy mode
[231]
Power limit mot.
N O T I C E
This option is only available in FC 302.
[232]
Power limit gen.
N O T I C E
This option is only available in FC 302.
[233]
Power limit both
N O T I C E
This option is only available in FC 302.
[234]
Light load + evacuation
N O T I C E
This option is only available in FC 302.
Parameter 5-21 Terminal X46/3 Digital Input
Table 347: Parameter 5-21 Terminal X46/3 Digital Input
5-21 Terminal X46/3 Digital Input
Default value: [0] No operation
Parameter type: Option
Setup: All setups
Conversion index: –
Data type: Uint8
Change during operation: True
The options for this parameter are the same as those listed for parameter 5-20 Terminal X46/1 Digital Input.
Parameter 5-22 Terminal X46/5 Digital Input
Table 348: Parameter 5-22 Terminal X46/5 Digital Input
5-22 Terminal X46/5 Digital Input
Default value: [0] No operation
Parameter type: Option
Setup: All setups
Conversion index: –
Data type: Uint8
Change during operation: True
The options for this parameter are the same as those listed for parameter 5-20 Terminal X46/1 Digital Input.
Parameter 5-23 Terminal X46/7 Digital Input
Table 349: Parameter 5-23 Terminal X46/7 Digital Input
5-23 Terminal X46/7 Digital Input
Default value: [0] No operation
Parameter type: Option
Setup: All setups
Conversion index: –
Data type: Uint8
Change during operation: True
The options for this parameter are the same as for those lited for parameter 5-20 Terminal X46/1 Digital Input.
AU275636650261en-000101 / 130R0334 | 197Danfoss A/S © 2022.12
Parameter Descriptions
VLT AutomationDrive FC 301/302
Programming Guide