Danfoss VLT AutomationDrive FC 302 - Page 325

Option
Name
Description
[0]*
No action
[1]
Power-on reset
[2]
Power-on reset prep
[3]
Comm option reset
Parameter 9-75 DO Identification
Table 566: Parameter 9-75 DO Identification
9-75 DO Identification
Default value: 0
Parameter type: Range, 0 - 65535
Setup: All setups
Conversion index: 0
Data type: Uint16
Change during operation:
Provides information about the DO (direct object). This parameter is for PROFINET only.
Parameter 9-80 Defined Parameters (1)
Table 567: Parameter 9-80 Defined Parameters (1)
9-80 Defined Parameters (1)
Default value: 0
Parameter type: Range, 0 - 9999
Setup: All setups
Conversion index: 0
Data type: Uint16
Change during operation: False
This parameter shows a list of all the defined drive parameters available for PROFIBUS.
Parameter 9-81 Defined Parameters (2)
Table 568: Parameter 9-81 Defined Parameters (2)
9-81 Defined Parameters (2)
Default value: 0
Parameter type: Range, 0 - 9999
Setup: All setups
Conversion index: 0
Data type: Uint16
Change during operation: False
This parameter shows a list of all the defined drive parameters available for PROFIBUS.
Parameter 9-82 Defined Parameters (3)
Table 569: Parameter 9-82 Defined Parameters (3)
9-82 Defined Parameters (3)
Default value: 0
Parameter type: Range, 0 - 9999
Setup: All setups
Conversion index: 0
Data type: Uint16
Change during operation: False
This parameter shows a list of all the defined drive parameters available for PROFIBUS.
Parameter 9-83 Defined Parameters (4)
Table 570: Parameter 9-83 Defined Parameters (4)
9-83 Defined Parameters (4)
Default value: 0
Parameter type: Range, 0 - 9999
Setup: All setups
Conversion index: 0
Data type: Uint16
Change during operation: False
This parameter shows a list of all the defined drive parameters available for PROFIBUS.
AU275636650261en-000101 / 130R0334 | 325Danfoss A/S © 2022.12
Parameter Descriptions
VLT AutomationDrive FC 301/302
Programming Guide