Danfoss VLT AutomationDrive FC 302

Option
Name
Description
[3457]
Synchronizing error
[3458]
Actual velocity
[3459]
Actual master velocity
[3460]
Synchronizing status
[3461]
Axis status
[3462]
Program status
[3464]
MCO 302 status
[3465]
MCO 302 control
[3466]
SPI error counter
[3470]
MCO alarm word 1
[3471]
MCO alarm word 2
[4029]
B-EMF protection log readout
[4280]
Safe option status
[4285]
Active safe func.
[4521]
Status
[4523]
Baseline failure
[4590]
Stator [%]
[4591]
Load [%]
[4592]
Sensor 1 [%]
[4593]
Sensor 1 [unit]
[4594]
Sensor 2 [%]
[4595]
Sensor 2 [unit]
[4596]
Sensor 3 [%]
[4597]
Sensor 3 [unit]
[4598]
Sensor 4 [%]
[4599]
Sensor 4 [unit]
Parameter 12-23 Process Data Config Write Size
Table 623: Parameter 12-23 Process Data Config Write Size
12-23 Process Data Config Write Size
Default value: 16
Parameter type: Range, 8 - 32
Setup: All setups
Conversion index: 0
Data type: Uint32
Change during operation: True
Use this parameter to configure the PCD write size in bits. Only values of multiples of 8 are valid.
AU275636650261en-000101 / 130R0334 | 359Danfoss A/S © 2022.12
Parameter Descriptions
VLT AutomationDrive FC 301/302
Programming Guide