Danfoss VLT AutomationDrive Design Guide

A – Top cover
B – Brim
C – Base part
D – Base cover
E – Screw(s)
F - Fan cover
G - Top clip
When option module A
and/or option module B
is/are used, the brim (B)
must be fitted to the top
cover (A).
E
F
D
C
B
A
VLT®
Automation Drive
130BT620.12
130BT621.12
D
C
VLT
®
AutomationDrive
A
G
B3 Enclosure B4 - C3 - C4 Enclosure
NOTE
Side-by-side installation is not possible when using the IP 21/ IP 4X/ TYPE 1 Enclosure Kit
Options and Accessories FC 300 Design Guide
250 MG.33.BD.02 - VLT
®
is a registered Danfoss trademark
10
10

Danfoss VLT AutomationDrive Specifications

General

Supply Voltage	3 x 200-240 V ±10% 3 x 380-500 V ±10% 3 x 525-600 V ±10%
Enclosure	IP20
Output Power Range	0.25 kW - 1.5 MW
Communication Protocols	Modbus RTU
Protection Features	Overcurrent, Overvoltage, Undervoltage, Short circuit, Ground fault, Motor overload
Ambient Temperature Range	-10°C to +50°C (14°F to 122°F)