9.1.2 Encoder Direction 233
9.1.3 Closed Loop Drive System 233
9.1.4 Programming of Torque Limit and Stop 233
10 Options and Accessories
235
10.1.1 Mounting of Option Modules in
Slot A 235
10.1.2 Mounting of Option Modules in
Slot B 235
10.1.3 Mounting of Options in Slot C 236
10.2 General Purpose Input Output Module MCB 101
236
10.2.1 Galvanic Isolation in the MCB 101 236
10.2.2 Digital Inputs - Terminal X30/1-4: 238
10.2.3 Analog Inputs - Terminal X30/11, 12: 238
10.2.4 Digital Outputs - Terminal X30/6, 7: 238
10.2.5 Analog Output - Terminal X30/8: 238
10.3 Encoder Option MCB 102
239
10.4 Resolver Option MCB 103
240
10.5 Relay Option MCB 105
241
10.6 24V Back-Up Option MCB 107
243
10.7 MCB 112 PTC Thermistor Card
244
10.8 MCB 113 Extended Relay Card
246
10.9 Brake Resistors
247
10.10 LCP Panel Mounting Kit
247
10.11 IP21/IP 4X/ TYPE 1 Enclosure Kit
248
10.12 Mounting Bracket for Frame Size A5, B1, B2, C1 and C2
251
10.13 Sine-wave Filters
253
10.14 High Power Options
253
10.14.1 Frame Size F Options 253
11 RS-485 Installation and Set-up
255
11.1 Overview
255
11.2 Network Connection
255
11.3 Bus Termination
255
11.4.1 EMC Precautions 256
11.5 Network Configuration
256
11.5.1 FC 300 Frequency Converter Set-up 256
11.6 FC Protocol Message Framing Structure - FC 300
257
11.6.1 Content of a Character (byte) 257
11.6.2 Telegram Structure 257
11.6.3 Length (LGE) 257
11.6.4 Frequency Converter Address (ADR) 257
Contents FC 300 Design Guide
MG.33.BD.02 - VLT
®
is a registered Danfoss trademark 5
To Next Page
Need help?
General
