Danfoss VLT Micro Drive FC 51 - Programming; Local Control Panel (LCP)

Mode 1
1. Enter the main menu.
2. Go to parameter group 1-** Load and Motor.
3. Press [OK].
4. Set motor parameters using nameplate data for
parameter group 1-2* Motor Data.
5. Go to 1-29 Automatic Motor Tuning (AMT).
6. Press [OK].
7. Select [2] Enable AMT.
8. Press [OK].
9. The test runs automatically and indicates when it
is complete.
Mode 2
1. Enter the main menu.
2. Go to parameter group 1-** Load and Motor.
3. Press [OK].
4. Set motor parameters using nameplate data for
parameter group 1-2* Motor Data.
5. Go to 1-29 Automatic Motor Tuning (AMT).
6. Press [OK].
7. Select [3] Complete AMT with Rotating motor.
8. Press [OK].
9. The test runs automatically and indicates when it
is complete.
NOTICE
In mode 2, the rotor rotates during the AMT progress.
Do not add any load on motor in this AMT progress.
Quick Guide
Quick Guide●Kurzanleitung●Guide rapide●Guía rápida●Guia Rápido●Краткое
руководство
MG02BB4P Danfoss A/S © 05/2016 All rights reserved. 15
1 1