x
SAFETY PRECAUTIONS
ELECTRICAL SAFETY
This product conforms to the applicable requirements contained in the European
Standard for electrical safety EN-60950 at the date of manufacture.
This symbol refers to operations that must be performed by
qualified personnel only. Example: opening the device.
This symbol refers to operations where there is danger of electrical
shock. Before opening the device make sure the power cable is
disconnected to avoid electric shock.
LASER SAFETY
The following information is provided to comply with the rules imposed by
international authorities and refers to the correct use of the DS8100 scanner.
Standard Regulations
This scanner utilizes up to 4 low-power laser diodes. Although staring directly at the
laser beam momentarily causes no known biological damage, avoid staring at the
beam as one would with any very strong light source, such as the sun. Avoid that the
laser beam hits the eye of an observer, even through reflective surfaces such as
mirrors, etc.
This product conforms to the applicable requirements of both IEC 825-1 and CDRH
21 CFR 1040 at the date of manufacture. The scanner is classified as a Class 2 laser
product according to IEC 825-1 regulations and as a Class II laser product according
to CDRH regulations.
There is a safety device which allows the laser to be switched on only if the motor is
rotating above the threshold for its correct scanning speed.
WARNING
Use of controls or adjustments or performance of procedures other
than those specified herein may result in exposure to hazardous
visible laser light.
To Next Page
Loading...
Need help?
General
