vi
BUS INTERFACE MODELS
The following can be used as a checklist to verify all the necessary steps for
complete installation of the DS8100 scanner.
1. Read all information in the section Safety Precautions at the beginning of this
manual.
2. Correctly position and mount the scanner for barcode reading according to the
information in paragraphs 3.2 and 3.4.
3. Provide correct system cabling according to the signals necessary (see
paragraph 3.3 and 3.5).
4. Configure your DS8100 by means of the SC8000 unit.
NOTE
Fine tuning of the scanner position for barcode reading can be
accomplished by performing a test through the SC8000 unit.
The installation is now complete.
To Next Page
Loading...
Need help?
General
