6-232 Magellan
®
8100/8100Ω and 8200/8200Ω Scanner
Codabar Length Control
This feature specifies whether variable-length or fixed-length decoding
will be set for Codabar.
To set this feature:
1. Scan the SWITCH bar code.
2. Scan your selection from the bar codes below. You’ll need to cover
any unused bar codes on this and the facing page to ensure that
the scanner reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the SWITCH
bar code.
CODABAR LENGTH CONTROL = VARIABLE-LENGTH
CODABAR LENGTH CONTROL = FIXED-LENGTH
NOTE
If variable-length control was selected, you must now set the features
Codabar Maximum Label Length and Codabar Minimum
Label Length. If fixed-length control was selected, you must now set
Codabar Fixed Length 1 and Codabar Fixed Length 2.
To Next Page
Loading...
Need help?
General
