6-242 Magellan
®
8100/8100Ω and 8200/8200Ω Scanner
Code 93 Maximum Label Length
This feature specifies the maximum allowable length of a Code 93 label.
To set this feature:
1. Scan the SWITCH bar code.
2. Scan the bar code, SET CODE 93 MAXIMUM LABEL
LENGTH below. You’ll need to cover any unused bar codes on
this and the facing page to ensure that the scanner reads only the
bar code you intend to scan.
3. Scan the appropriate digits from the keypad in Appendix C that
represent the desired maximum label length. The selectable range
for this option is 01 to 50. Pad all single digit numbers with a
leading zero to yield a two-digit entry (01-50).
4. Complete the programming sequence by scanning the SWITCH
bar code.
SET CODE 93 MAXIMUM LABEL LENGTH
NOTE
Length in this case includes data characters, but does not include start,
stop, full ASCII shift, or check characters. This feature applies when
Code 93 Length Control is set to variable-length decoding.
Maximum label length should be greater than or equal to minimum label
length.
To Next Page
Loading...
Need help?
General
