Product Reference Guide 6-241
Code 93 Length Control
This feature specifies whether variable-length or fixed-length decoding
will be set for Code 93.
To set this feature:
1. Scan the SWITCH bar code.
2. Scan your selection from the bar codes below. You’ll need to cover
any unused bar codes on this and the facing page to ensure that
the scanner reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the SWITCH
bar code.
CODE 93 LENGTH CONTROL = VARIABLE-LENGTH
CODE 93 LENGTH CONTROL = FIXED-LENGTH
NOTE
If variable-length control was selected, you must now set the features
Code 93 Maximum Label Length and Code 93 Minimum Label
Length. If fixed-length control was selected, you must now set Code 93
Fixed Length 1 and Code 93 Fixed Length 2.
To Next Page
Loading...
Need help?
General
