Enter/Exit Programming Mode
132
PowerScan™ PD9130/PBT9100/PM9100
Datalogic 2 of 5 Length Control
This feature specifies either variable length decoding or fixed length decod-
ing for the Datalogic 2 of 5 symbology.
Variable Length.
For variable length decoding, a minimum and maximum length may be
set.
Fixed Length.
For fixed length decoding, two different lengths may be set.
Datalogic 2 of 5 Length Control = Variable Length
Datalogic 2 of 5 Length Control = Fixed Length
Datalogic 2 of 5 Set Length 1
This feature specifies one of the bar code lengths for Datalogic 2 of 5
Length Control. Length 1 is the minimum label length if in Variable Length
Mode, or the first fixed length if in Fixed Length Mode. The length includes
the bar code’s data ch
aracters only.
The length can be set from 2 to 50 characters in increments of two. See Set Length 1 on
page 297
for more detailed programming instructions.
Select Datalogic 2 of 5 Length 1 Setting
To configure this feature, scan the ENTER/EXIT bar
code above, then the bar code at left followed by
digits from the Alphanumeric characters in
Appendix D, Keypad representing your desired
character(s). End by scanni
ng the ENTER/EXIT bar
code again.
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
CANCEL
06 = Length 1 is 6 Characters
DEFAULT
To Next Page
Loading...
Need help?
General
Weight and Dimensions
