EasyManuals Logo

Datalogic PowerScan PBT9100 User Manual

Datalogic PowerScan PBT9100
362 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #29 background imageLoading...
Page #29 background image
Customizing Configuration Settings
Product Reference Guide
17
Customizing Configuration Settings
Configure Interface Settings
If after scanning the interface bar code from the previous table, your instal-
lation requires you to select options to further customize your reader, turn
t
o the appropriate section for your interface type in "Configuration Parame-
ters" st
arting on page 21.
Global Interface Features
See "Global Interface Features" on page 23 for settings configurable by all
interface types.
Configuring Other Features
If your installation requires different programming than the standard factory
default settings, the following sections of this manual allow configuration of
non-interface-specific settings you might require. Go to Configuration
Using Bar Codes, starting on page 21 for a complete list of available options.
Software Version Transmission
The software version of the device can be transmitted over the RS-232 and
Keyboard interfaces by scanning the following label.
Transmit Software Version
Resetting the Product Configuration to Defaults
Restore Custom Defaults
If you aren’t sure what programming options are in your imager, or you’ve
changed some options and want to restore the Custom Default Configura-
tion that may have been saved in the scanner, scan the Restore Custom
De
fault Configuration bar code below. This will restore the custom configu-
ration for the currently active interface.
Custom defaults are based on the interface type. Configure the
imager for the correct interface before scanning this label.
Restore Custom Default Configuration

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Datalogic PowerScan PBT9100 and is the answer not in the manual?

Datalogic PowerScan PBT9100 Specifications

General IconGeneral
Harmonized System (HS) code84716070
TypeHandheld bar code reader
Sensor typeLED
Scanner type1D
Yaw reading angle-70 - 70 °
Scanner resolution0.13 mm
Tilt reading angle-45 - 45 °
Pitch reading angle-75 - 75 °
Linear (1D) barcodes supportedCodabar, Code 11, Code 128, Code 32, Code 39, Code 39 (ASCII), Code 93, EAN 128, GS1 DataBar, IATA, ISBN, Industrial 2 of 5, Interleaved 2 of 5, MSI, Plessey, UPC-A, UPC-E
2D (matrix & stacked) barcodes supported-
Wireless range100 m
Bluetooth version3.0
Operating frequency2.4-2480 MHz
Standard interfacesBluetooth, RS-232
Connectivity technologyWireless
CertificationIEC 62471
Product colorBlack, Yellow
LED indicatorsYes
International Protection (IP) codeIP65
Battery life10 h
Battery typeBuilt-in battery
Charging time4.5 h
Input voltage10-30 V
Battery capacity3350 mAh
Power consumption500 mA
Power source typeBattery
AC adapter output voltage110 V
Number of reads per charge60000
Power consumption (typical)10 W
Cables includedDC, RS-232
Storage temperature (T-T)-40 - 70 °C
Operating temperature (T-T)-20 - 50 °C
Operating relative humidity (H-H)5 - 95 %
Warranty period3 year(s)
Sustainability certificatesRoHS
Weight and Dimensions IconWeight and Dimensions
Depth74 mm
Width110 mm
Height240 mm
Weight405 g
Base dimensions212 x 110 x 74 mm

Related product manuals