234
PowerScan™ PD9130/PBT9100/PM9100
PBT9100-ONLY FEATURES
The features in this section are valid only for PBT9100 Bluetooth models.
Also reference the Setup section for instructions, see the paragraph Linking
the Reader on page 19.
BLUETOOTH SECURITY FEATURES
On the Bluetooth system, it is possible to set a (configurable) PIN code to
authenticate/connect Bluetooth devices, and encrypt the data.
The Bluetooth PIN code can be enabled and configured by reading the bar
codes in the following sections.
If you are using a Bluetooth scanner directly connected to a host through a Blue-
tooth dongle, verify that the scanner and th
e Bluetooth driver used by the dongle
share the same PIN code and the same security level. Otherwise the connection
cannot be established.
Follow these steps to set the PIN code for a scanner:
1. Enable Bluetooth Security Mode by scanning the “Enable” bar code
below.
2. Se
lect a PIN code length of either 4 or 16 characters by scanning the
appropriate bar code in Select PIN Code Length on page 235.
3. Scan the relevant bar code from Set PIN Code on page 236, then scan
the desired alphanumeric characters from the keypad in Appendix D,
Keypad to set the PIN code.
See page 312 in “References” for more detailed information and examples
for this feature.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
