Enter/Exit Programming Mode
Product Reference Guide
267
Set String Terminator
Sets the terminator of the predefined strings.
Set String Terminator
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at l
eft followed by 32 digits from the Alphanumeric
characters in
Appendix D, Keypad.
The digits must be the hexadecimal ASCII representa-
tion of the desired characte
rs. If less than the
expected string of 16 characters are selected, scan
the ENTER/EXIT bar code to terminate the string.
If the first 2 digits are 0, the feature is disabled. End
by scanni
ng the ENTER/EXIT bar code twice.
Make a mistake? Scan the CANCEL
bar code to abort
and not save the entry string. You can then start
again at the beginning.
CANCEL
To Next Page
Loading...
Need help?
General
Weight and Dimensions
