Enter/Exit Programming Mode
Product Reference Guide
283
Set Barcode Terminator
Sets the terminator for barcode and keyboard composed strings.
Set barcode terminator
To configure this feature, scan the ENTER/EXIT PROGRAM-
MING MODE bar code above, then the bar code at left fol-
lowed by 32 digits from the Al
phanumeric characters in
Appendix D, Keypad
. The digits must be the hexadeci-
mal ASCII representation of the desired characters.
If less than the expected string of 16 characters are
se
lected, scan the ENTER/EXIT bar code to terminate the
string. If the first 2 digits are 0, the feature is disabled. End
by scanning the ENTER/EXIT bar code twice.
Set Key Sequence ID
Sets the identifier for keyboard composed strings.
Set keys sequence ID
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at left
fol
lowed by 6 digits from
Appendix D, Keypad
.
The ID characters must be represented by their hexadeci-
mal ASCII code; if the first 2 digits are 0, this feature is dis-
abled. End by scanning the ENTER/EXIT bar code twice.
Set Key Sequence Header
Sets the header for keyboard composed strings.
Set key sequence header
To configure this feature, scan the ENTER/EXIT PROGRAM-
MING MODE bar code above, then the bar code at left fol-
lowed by 32 digits from the Alphanumeric characters in
Appendix D, Keypad
. The digits must be the hexadeci-
mal ASCII representation of the desired characters.
If less than the expected string of 16 characters are
selected, scan
the ENTER/EXIT bar code to terminate the
string.
If the first 2 digits are 0, the feat
ure is disabled. End by
scanning the ENTER/EXIT bar code twice.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
