Enter/Exit Programming Mode
Product Reference Guide
55
INDIVIDUALLY SET LABEL ID
This feature configures a Label ID individually for a single symbology. To
set, first define whether you want it as a prefix or suffix by scanning a label
below. Then turn to Label ID Symbology Selection, starting on page 56 to
select the symbology you want to set, fol
lowed by up to 3 characters from
the ASCII Chart at the back of this manual. See "Label ID:
Set Individually Per
Symbology" on page 304 for detailed instructions on setting this feature.
Label ID Control
This option controls whether a Label ID is disabled, or sent as a prefix or
suffix for a given symbology type.
DEFAULT
Label ID Transmission = Disable
Label ID Transmission = Enable as Prefix
Label ID Transmission = Enable as Suffix
CANCEL
Make a mistake? Scan the CANCEL bar code
to abort and not save the entry string. You
can then start again at the beginning.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
