76
PowerScan™ PD9130/PBT9100/PM9100
Default settings are indicated at each feature/option with a green arrow.
Also reference Appendix C, Standard Defaults for a listing of the most widely
used set of standard factory settings.
That section also provides space to
record any custom settings needed or implemented for your system.
To set most features:
1. Scan the ENTER/EXIT PROGRAMMING bar co
de at the top of applicable
programming pages.
2. Scan the correct bar code to set th
e desired programming feature or
parameter. You may need to cover unused bar codes on the page, and
possibly the facing page, to ensure that the reader reads only the bar
code you intend to scan.
3. If additional input parame
ters are needed, go to Appendix D, Keypad,
and scan the appropriate characters from the keypad.
Additional information about many features can be found in the
“References” chapter.
If you make a mistake before the la
st character, scan the CANCEL
bar code to abort and not save the entry string. You can then start
again at the beginning.
4. Complete the programming sequence by scanning the ENTER/EXIT
PROGRAMMING bar code to exit Programming Mode.
GS1 DATABAR™ EXPANDED on page 170
GS1 DATABAR™ LIMITED on page 175
CODE 93 on page 177
CODABLOCK F on page 184
CODE 4 on page 188
CODE 5 on page 190
CODE 4 AND CODE 5 COMMON CONFIGURATION ITEMS on page 192
BC412 on page 194
MSI on page 200
PLESSEY (ONLY STANDARD OPTIC MODELS) on page 206
To Next Page
Loading...
Need help?
General
Weight and Dimensions
