STANDARD DEFAULTS
180
QUICKSCAN™ I QD2200
USB-OEM Interface Options
Ignore Scanner Configuration
Host Commands
37
DATA FORMAT
Global Prefix/Suffix
No Global Prefix
Global Suffix = 0x0D (CR)
39
Global AIM ID Disable 40
GS1-128 AIM ID Enable 40
Label ID: Pre-loaded Sets USA Set 41
Label ID Control Disable 42
Label ID Symbology Selection 43
Case Conversion Disable (no case conversion) 48
Character Conversion
0xFFFFFFFFFFFFFFFF
(no character conversion)
48
READING PARAMETERS
Scan Mode Trigger Single 50
Scanning Active Time 5s 51
Flash On Time 10 = Flash is ON for 1 Second 51
Flash Off Time 06 = Flash is OFF for 600ms 52
Double Read Timeout 0.6 second 52
Stand Mode/Object Detection Sensi-
tivity
Medium 54
Stand Mode/Object Detection Illumi-
nation Off Time
04 = Illumination OFF Time 2
second
55
Power On Alert
Power On Alert = Power-up Beep
56
Good Read Beep Type Mono 56
Good Read Beep Frequency High 57
Good Read Beep Length 80 msec 58
Good Read Beep Volume High 59
Green LED Good Read Enable Enable 60
Good Read LED Duration 300 ms. 61
Good Read: When to Indicate After Decode 62
Green Spot Duration Short (300 msec) 63
CODE SELECTION
PARAMETERS DEFAULT
YOUR SETTING PAGE NUMBER
To Next Page
Loading...
