vPad-A1 OPERATORS MANUAL
6 Calibration and Maintenance
Calibration of vPad-A1* by a Datrend Authorized Service facility is recommended on an
annual
basis, and
is
required
to extend the product warranty. The basic one (1) year warranty on all Simulator and Tester
Units can be extended to a maximum of two (2) years provided that annual calibration is performed by a
Datrend Authorized Service Center on an
annual
basis. Refer to the Calibration Decal applied to the
bottom of each Simulator or Tester Unit to determine calibration status of your vPad-A1.
vPad-A1 contains no user serviceable parts.
Opening the case of vPad-A1 for any reason will void the
warranty and may compromise user safety.
Service must be performed by a factory trained, authorized service agent.
This unit may contain hazardous voltages which may cause injury if correct
service procedures are not followed.
For calibration or service assistance, contact Datrend for a Return Materials Authorization (RMA) number
and the location of the nearest Service Facility.
Datrend Systems Inc.
Unit 130 - 4020 Viking Way
Richmond, BC • CANADA • V6V 2L4
Tel 604.291.7747 or 800.667.6557 • Fax 604.294.2355
e-mail customerservice@datrend.com
www.datrend.com
vPad-A1 may be cleaned with a soft, lint free, damp cloth using a mild detergent. Use of other cleaning
agents on the touchscreen may result in scratching, discolouration, streaking or even failure.
Electrical safety protection of the operator may be compromised if the
instructions in this manual are not followed, or if vPad-A1 is used for a
purpose not specified in this manual.
* reference to vPad-A1 includes the Base, tablet, vPad-PS, vPad-O2 and/or vPad-BP module(s)
Maintenance/Chapter 6 # Page 89
To Next Page
Loading...
Need help?
General