vPad-A1 OPERATORS MANUAL
5.2.2.2 Creating and Editing AutoSequences
After an AutoSequence has been selected from the list, its name will be displayed in the menu box
and the Run button will be enabled (turned from gray to green). At this point this AutoSequence is
available for editing.
There are two main methods to create a new AutoSequence: start
from scratch, or use an existing sequence as template. In the
example following, an sample AutoSequence “Hypertensive” will
be edited to create a new sequence, and to illustrate the normal
process used to create and/or change the sequence groups.
With the item “Hypertensive” visible in the AutoSequence list box,
touch the button and the Editor menu will be
displayed.
The Editor menu is divided into three sections:
• the AutoSettings selector;
• the AutoSequence tree viewer (for working with Groups); and
• the Action Controls toolbar
Note that the Action Controls toolbar can be enlarged:
Figure 130
The larger toolbar may be displayed by pressing either of the
buttons at bottom left and right on the screen.
Figure 128
Figure 129
Automation and Test Records/Chapter 5 # Page 84
To Next Page
Loading...
Need help?
General