DEC DECpc LPx - Chapter 4 Troubleshooting; Initial Troubleshooting

Digital DECpc LPx/LPx+ Troubleshooting
MCS Logistics Engineering - Nijmegen 73
Chapter 4 Troubleshooting
The following pages provide initial troubleshooting procedures and tables listing specific problems,
probable causes, and recommended actions to take if the computer fails after configuration or after
installation of optional hardware or software.
Refer to the documentation supplied with additional options when experiencing problems with specific
options that have been installed.
Initial Troubleshooting
Follow these general procedures to troubleshoot the DECpc LPx/LPx+ computer:
♦ Press [Ctrl] + [Alt] + [Del]. If the computer fails to boot, turn it off, wait until all hard disk drives spin
down completely, and then turn it back on.
♦ Ensure that all cables and connections are secure.
♦ If the POST detects an error refer to “Troubleshooting” and take the appropriate steps to correct the
problem. After the problem has been resolved, restart the computer.
♦ Run the diagnostic software.
♦ Run the BIOS Setup utility.
NOTE
If you need to return a failed component, pack it in its original container and return it to
Digital for service.
Fill in the appropriate fields of the Part Exchange Form with the relevant error information!!