Digital DECpc LPx/LPx+ Pass / Fail Criteria
MCS Logistics Engineering - Nijmegen 89
Chapter 6 Pass / Fail Criteria
As Final Acceptance Test the following tests should be run to meet the Pass/Fail criteria:
1) Successful completion of the POST tests.
2) Successful completion of the following QAPLUS/fe module tests (one pass):
♦ System Board (all tests)
♦ Memory (all tests)
♦ Video (all tests)
♦ ♦ Hard Disk (all tests, except: Sequential write/read (destructive test !!) and
♦ Sequential write/random read (destructive test !!))
♦ Floppy Disk (all tests)
♦ Keyboard (all tests)
♦ COM Ports (all tests)
♦ LPT Ports (all tests)
♦ Pointer Device (all tests)
3) Successful bootstrap of the on the computer installed Operating System.
Operating Systems Supported:
◊ MS-DOS version 5.0 and later
◊ OS/2 version 2.0 and later
◊ SCO Open Desktop Release 3
◊ Windows NT (DECpc LPx+ with 12 MB client/ 16 MB server memory minimum
recommended)
◊ SCO UNIX System V release 2.0 and later
Remove any software that was put on the hard drive to enable repair of the system before shipping.
When completed carefully clean the outside of the unit with cleaning solution.
To Next Page
Loading...