Figure 86. Installing expansion card into the expansion card riser 3
Next steps
1 If applicable, connect the cables to the expansion card.
2 If removed, install the air shroud.
3 Follow the procedure listed in After working inside your system.
4 Install any device drivers required for the card as described in the documentation for the card.
Removing the riser 2 and 3 blank
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
3 Remove the air shroud.
Steps
1 Using a Phillips #2 screwdriver, loosen the screws that secure the blank to the system.
2 Press the release tab, and holding the blank by its edges, lift the blank away from the system.
Installing and removing system components 131
To Next Page
Loading...
