Dell EMC PowerEdge R7425 - Installing the IDSDM or Vflash Module

Figure 99. Removing the IDSDM or vFlash module
Next step
Install the IDSDM or vFlash module
.
Installing the IDSDM or vFlash module
Prerequisite
Follow the safety guidelines listed in Safety instructions
.
Steps
1 Locate the IDSDM or vFlash connector on the system board.
To locate IDSDM or vFlash connector, see the System board jumpers and connectors section.
2 Align IDSDM or vFlash module with the connector on the system board.
3 Push IDSDM or vFlash module until it is rmly seated on the system board.
Installing and removing system components 143