Dell EMC PowerEdge R7425 - Removing the Expansion Card Riser 3; Installing the Expansion Card Riser 3

6 Install any device drivers required for the card as described in the documentation for the card.
Removing the expansion card riser 3
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
3 If applicable, close the PCIe card holder latch on the air shroud to release the full-length PCIe card.
4 Remove the air shroud
.
5 If installed,
remove expansion cards installed on the riser.
6 Disconnect any cables connected to the riser card.
Steps
1 Using a Phillips #2 screwdriver, loosen the screw that secures the riser to the system.
2 Holding the riser by its edges, lift the riser from the slot on the system and riser connector on the system board.
Figure 97. Removing the expansion card riser 3
Next step
Install the expansion card riser 3
.
Installing the expansion card riser 3
Prerequisite
Follow the safety guidelines listed in Safety instructions.
Steps
1 Align the tab on the riser with the slot on the system, and guide rails on the riser with the st
andos on the side of the system.
2 Lower the riser into the system until the riser edge connector engages with the connector on the system board.
The riser card edge engages with the riser guide on the system.
140 Installing and removing system components