Dell EMC PowerEdge R7425 - USB 3.0 Module; Removing the USB 3.0 Module

Figure 128. Removing the system battery
3 To install a new system battery, hold the battery with the positive side facing up and slide it under the securing tabs.
4 Press the battery into the connector until it snaps into place.
Figure 129. Installing the system battery
Next steps
1 Install the expansion card riser 1.
2 If applicable, connect the cables to the expansion card(s) in the expansion card riser 1.
3 If applicable, open the PCIe card holder latch on the air shroud to secure the full length expansion card.
4 Follow the procedure listed in After working inside your system.
5 While booting, press F2 to enter the System Setup and ensure that the battery is operating properly.
6 Enter the correct time and date in the System Setup Time and Date elds.
7 Exit the System Setup.
USB 3.0 module
An additional USB 3.0 port can be added to the front of the system. The USB 3.0 module cable connects to the internal USB port on the
system board. In this scenario, the default internal USB port is available under the backplane cover.
NOTE: The position of the USB 3.0 module and default internal USB port may vary depending on the conguration of your
system.
Removing the USB 3.0 module
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
3 Remove the backplane cover.
4 Remove the cooling fan assembly.
5 Remove the air shroud
.
166 Installing and removing system components