Figure 92. Installing the expansion card riser 1
Next steps
1 If removed, install the expansion cards into the riser.
2 Connect the cables to the riser.
3 Follow the procedure listed in After working inside your system.
4 Install any device drivers required for the card as described in the documentation for the card.
Removing the expansion card riser 2
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
3 If applicable, close the PCIe card holder latch on the air shroud to release the full-length PCIe card.
4 Remove the air shroud
.
5 If installed,
remove the expansion cards installed on the riser.
6 Disconnect any cables connected to the riser.
Steps
1 To remove expansion card riser 2A or 2E:
a Using a Phillips #2 screwdriver, loosen the screws that secure the riser to the system.
b Press the release tab, and holding the riser by its edges, lift the riser from the riser connector on the system board.
Installing and removing system components 137
To Next Page
Loading...
