Steps
1 Disconnect the VGA cable from the system board.
2 Lift the cable latch and disconnect the control panel cable from the system board connector.
3 Using a Phillips #1 screwdriver, remove the screws that secure the control panel and cable tube to the system.
4 Holding the control panel and cable tube by its sides, remove the control panel and cable tube away from the system.
Figure 140. Removing the right control panel
Next step
Install the right control panel.
Installing the right control panel
Prerequisite
Follow the safety guidelines listed in Safety instructions.
Steps
1 Route the control panel cable and VGA cable through the side wall of the system.
2 Align the control panel with the control panel slot on the system and attach the control panel to the system.
3 Connect the VGA cable to the system board.
4 Connect the control panel cable to the system board and secure it using cable latch.
5 Using a Phillips #1 screwdriver, install the screws that secure the control panel and cable tube to the system.
Installing and removing system components 179
To Next Page
Loading...
