Figure 90. Installing the riser 3 blank
Next steps
1 Install the air shroud.
2 Follow the procedure listed in After working inside your system.
Removing the expansion card riser 1
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
3 If installed, remove the expansion cards from the riser.
4 Disconnect any cables connected to the riser.
Step
Press the release latches, and slide the riser to disengage the slots on the riser from the guides on the system.
Installing and removing system components 135
To Next Page
Loading...
