Dell EMC PowerEdge R7425 - Control Panel; Removing the Left Control Panel

3 Rotate the rubber cap clockwise to x it o
ver the captive screws.
4 Insert the mating connector into the power supply.
Control panel
A control panel allows you to manually control the inputs to the server.
Your system supports:
• Left control panel: Contains status LEDs, system ID button, and iDRAC Quick Sync 2 (optional).
• Right control panel: Contains power button, USB 2.0 ports, VGA port, micro USB for iDRAC Direct, and status LED for iDRAC Direct.
Removing the left control panel
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
3 Remove the cooling fan assembly.
4 Remove the air shroud
.
NOTE
: Ensure that you note the routing of the cables as you remove them from the system board. You must route the
cables properly when you replace them to prevent the cables from being pinched or crimped.
Steps
1 Lift the cable latch and disconnect the control panel cable from the system board connector.
2 Using a Phillips #1 screwdriver, remove the screws that secure the control panel and cable tube to the system.
3 Holding the control panel and cable tube by its sides, remove the control panel and cable tube away from the system.
Figure 138. Removing the left control panel
Next step
Install the left control panel.
Installing and removing system components 177