Figure 93. Removing the expansion card riser 2A or 2E
2 To remove expansion card riser 2B or 2C, hold the riser by its edges and lift the riser from the riser connector on the system board.
Figure 94. Removing the expansion card riser 2B or 2C
Next step
Install the expansion card riser 2
.
Installing the expansion card riser 2
Prerequisite
Follow the safety guidelines listed in Safety instructions
.
Steps
1 To install expansion card riser 2A:
a Align the screw and slot on the riser with the screw hole and guide pin on the system.
138 Installing and removing system components
To Next Page
Loading...
